Basic Turning

The double clamp type is for locking an insert (with a hole) into the main body of the holder pocket and side with a single action.

This method uses an L shaped lever to clamp the insert on two walls of the insert pocket.

This method uses a double clamping method that locates the insert on the top face and depending on the insert geometry on either one or two side faces.

This method uses an insert with a tapered hole. The insert is located in the pocket using a screw.

This method uses a clamp that locates the insert by clamping on the top face of the insert. The clamp on type utilizes a breaker piece, so it is used for inserts without a breaker.

This method uses a pin that is set of centre, thus when the cam is rotated it pushes the insert into the pocket and clamps.