For steels
For stainless steels
For cast iron
For non-ferrous metal
For difficult to cut material
For hardened material
In general, when cutting speed increases, the chip control range tends to become narrower.
If the cutting speed is the same, the range of chip control differs according to whether coolant is used or not.
Technical consultation from here
24/7Contact formNecessary cookies are used to help this website function properly.
For example, they provide login retention functionality.
Analytical cookies collect information about your use of this website in an anonymous and aggregated form. These cookies are used to analyze and improve the functionality of this website.
These cookies enable this website to provide enhanced functionality and personalisation. They may be set by us or by third party providers.
Functional cookies are used by social networking services to track the use of their built-in features. For example, these cookies allow you to share pages from this website with your social network.
Advertising cookies may be set through this website by our advertising partners based on the data obtained. They identify your unique browser and Internet device and may be used to provide anonymized demographic data, build profiles of your interests, and display advertising relevant to those interests.
For steels
For stainless steels
For cast iron
For non-ferrous metal
For difficult to cut material
For hardened material
For finish cutting
For medium cutting
For rough cutting