Seleção do calço para Linha MMT

Flank Angle and Lead Angle

Lead angle (α) depends on a combination of thread diameter and pitch. Select a shim so that the lead angle of the thread can coincide with the flank angles of the thread and insert (β1、β2). No need to change a shim for general threading with an MMT holder.
When threading with a small diameter or large pitch, change the shim depending on the lead angle, referring to the table and graph below. When threading left hand threads, change to a shim with a negative inclination angle.

Shim Reference Table (Threading Diameter) (Thread Angle 60˚ and 55˚)

Shim Reference Graph (Thread Angle 60˚ and 55˚)

Right Hand Thread

Left Hand Thread

(Note) When a thread lead angle < the tool flank angle, change the shim to prevent side interference with the insert.
(Refer to the table below for the calculation of thread lead angle and tool flank angle.)

Shim Reference Table (Threading Diameter) (Thread Angle 30˚ and 29˚)

Shim Reference Graph (Thread Angle 30˚ and 29˚)

Right Hand Thread

Left Hand Thread

(Note) When a thread lead angle < the tool flank angle, change the shim to prevent side interference with the insert.
(Refer to the table below for the calculation of thread lead angle and tool flank angle.)

Selection Table

Example of Selecting a Shim

・When the thread lead angle is 2.2°
　1. In the case when the thread helix angle is 60°
(2.2° lead angle) ─ (2.5─0.5°) = -0.3°─1.7° shim inclination angle is appropriate.
Threading with a standard shim (0° inclination angle) is possible. But, replacing with a shim with a 1° inclination angle is recommended.

　2. In the case when the thread helix angle is 30°
(2.2° lead angle) ─ (2─1°) = -0.2°─1.2° shim inclination angle is appropriate.
Replacing with a shim with a 1° inclination angle is recommended.

Calculation of Thread Lead Angle

Relief Angle of an Insert Set on a Holder

• Relief angles (β2, β1) of an insert become small when the thread helix angle of a trapezoidal, round, or other thread is small.Take care when selecting a shim.